Parting of the CJ-7 Lots of quality parts, Suburban/trailer

Sell you spare parts here

Moderator: phpBB2 - Administrators

Lifted Wheeler
Posts: 90
Joined: Wed Dec 14, 2005 9:06 am
Location: Franklin, Ohio

Parting of the CJ-7 Lots of quality parts, Suburban/trailer

Postby SWOhioJeepDude » Sun Sep 12, 2010 12:26 pm

Standard front drive shaft - $75

Currie HI-9 rear (custom Ford 9” high pinion), 4.10, full spool, 33 spline shafts, 3/4 ton disk brakes, spring plates to conceal U-bolt nuts, 58.5in wide (perfect fit), includes 4.56 gears. - $1600

Dana 44 Scout front, 4.10, Detroit Tru Trac, 4 degree yoke caster, Dana 30 outers, warn lock outs, complete spare shafts (set), new bearings and seals through out 3/07
custom steering linkage, 1.1/4OD x .3/4ID DOM, 3/4 x 3/4 rod ends, drives straight down the road, no pulling or swaying (unless aired down) - $400

CJ-7 Frame front spring out-board mounts to accommodate Scout Dana 44 - Great Condition - $100
front Revolver shackles - $150

Customer front bumper, protects revolver shackles, steering box, built with angle to slide up rocks and built in winch mounting plate - $100

custom made family roll bar, no bar in front - $75
Bestop Sunrider softtop good condition including frame few missing parts - $200

1992 Jeep Wrangler 4.0HO I6 engine complete. Needs fuel pump, exhaust manifold and replacement poly-part for the motor mount. Installation will require mounting of sensor into the transmission that I have. The engine has 170K. - $500

Pictures of Jeep
<a href="" rel="nofollow"></a>

Scot VanWoert
937.287.3390 day
937.743.9175 evening
Franklin, Ohio

The trailer....
Originally this was a camper converted to this near 15 foot tandem dual brake trailer. The baby is low to the ground and pulls straight as an arrow. Brakes good but could use a set of real trailer tires. - $750

Pictures of Trailer
<a href="" rel="nofollow"></a>

Return to Buy.. Sell.. Trade..

Who is online

Users browsing this forum: No registered users and 2 guests